Table 2-5. Remote Control Panel, Controls and Instruments

Figure 2-12. Single Generator Unit, Operating Instructions with Housing Kit Installed

Figure 2-13. Remote Control Module Panel

TM-5-6115-593-12 Power Plant Utility (MUST) Gas Turbine Engine Driven (AMERTECH Corp Model APP-1) Manual
Page Navigation
59

TM 5-6115-593-12 TO 35C2-3-463-1 2-10. OPERATION WITH THE REMOTE CONTROL MODULE AND CABLE. Addition of the remote control module and cable allows operation of the engine/generator set from distances of up to 100 feet (30 meters). The purpose and location of controls on the remote control module panel are described in table 2-5 and illustrated in figure 2-13. It should be noted that the controls on the remote control module are almost identical to those on the generator control panel. a. Connection Procedure for Using Remote Control Module and Cable. WARNING Do not attempt to make connections to the control cubicle while generator set is in operation. (1) Connect the remote control cable to the remote control module by connecting plug P4 to receptacle J4, plug P1 to receptacle J1, and plug P2 to receptacle J2. (2) Connect the other end of the remote control cables to the back side of generator set control cubicle by connecting plug P4 to receptacle J4, plug P1 to receptacle J1, and plug P2 to receptacle J2. (3) Remove terminal board jumper connections in control cubicle as shown in figure 2-14. b. Use of Remote Control Module. Figures 2-15, 2-16, 2-17, and 2-18 provide preparation, starting, stopping and operating instructions for generator set equipped with a remote control module. c. Emergency Stopping. To stop the generator set from the remote control module in an emergency, place the EMERGENCY SHUT-DOWN switch in the ON position. Table 2-5. Remote Control Panel, Controls and Instruments FIGURE, NORMAL INDEX NO. CONTROL AND INSTRUMENT FUNCTION READING/SETTING 2-13,1 VOLT ADJ INCREASE- Permits adjustment of Neutral DECREASE generator set voltage output. 2-13,2 BATTLE SHORT lamp Indicates BATTLE SHORT OFF switch is ON. 2-13,3 VOLTMETER-BUSS VOLT-GEN Selects BUSS 1-2, GEN — — VOLT switch 1-2, GEN 2-3, BUSS 2-3, GEN 3-1, and BUSS 3-1. 2-13,4 FREQ ADJ INCREASE- Switch to adjust gene- Neutral DECREASE rator at frequency 2-13,5 VOLTS AC meter Indicates AC output 120/208 or voltage. 240/416 2-13,6 HERTZ frequency meter Indicates generator set. 50 Hz: 48.2- frequency in Hz. 51.8 Hz 58.2 60 Hz: 61.8 Hz 2-13,7 AMMETER switch Selects phase 1, 2 or 3. As desired. 2-28

Privacy Statement
Press Release
Contact