Figure 4-55. Coolant Temperature Switch
Replacement. Screw temperature switch into
water manifold. Connect electrical connector.
Refill with coolant in accordance with table 4-1.
Check for leakage, tighten if necessary.
4-83. VIBRATION DAMPER AND CRANKSHAFT
PULLEY. (See figure 4-40.) The vibration damper and
crankshaft pulley are mounted on the front end of the
crankshaft. Inspect as follows:
Inspect pulley belt grooves for step wear along
Inspect pulley belt grooves around total
circumference of pulley for cracks or distortion.
Inspect hub area for cracks.
For replacement refer to next higher level of
4-84. INTERCOOLER. (See figure 4-40.) The
intercoolers are mounted on top of the engine on each
side as shown in figure 4-40.
Inspection. (See figure 4-56.)