TM 5-6115-585-12
NAVFAC P-8-623-12
TO 35C2-3-455-1
TM-05682C/05685B-12
(c)
Apply adhesive backed teflon tape to left
support assembly top surface (slotted surface which mounts
against underside of skid).
Use hand pressure to remove air
bubbles.
(d) Clear tape from slotted openings.
(3) Right Support Assembly (refer to figure 5-8,
item 3).
(a)
Wipe surface clean.
(b) Cut a 61 in. length of adhesive backed teflon
tape from supplied bulk material.
(c)
Apply adhesive backed teflon tape to right
support assembly top surface (slotted surface which mounts
against underside of skid).
Use hand pressure to remove air
bubbles.
(d) Clear tape from slotted openings.
(4)
Side Closure Assembly (refer to figure 5-4,
item 13).
(a)
Wipe surface clean.
(b) Cut a 20 1/2 in. length and a 29 1/4 in.
length of adhesive backed teflon tape from supplied bulk
material.
(c)
Apply adhesive backed teflon tape to top
edges (edges with four holes) and left edge (edge with three
holes).
Use hand pressure to remove air bubbles.
(d) Clear tape from holes.
(5) Rear Closure Assembly (refer to figure 5-10,
item 6).
(a)
Wipe surface clean.
(b) Cut a 23 in. length and a 14 in. length of
adhesive backed teflon tape from supplied bulk material.
(c)
Apply adhesive backed teflon tape to top edge
(edge with three holes) and right edge (edge with two holes which
contacts right panel assembly).
Use hand pressure to remove air
bubbles.
(d) Clear tape from holes.
5-26
Change 8
