TM 5-6115-585-12NAVFAC P–8-623-12TO 35C2-3-455-1TM-05684C/05685B-12d.Install ASK replacement components by following theapplicable installation procedures outlined in Section II.5-17. LATCHREPLACEMENT.The following procedures are for replacement of side closure doorlatch assemblies.Figure 5-12 (Illustration A) shows a typicallatch assembly replacement.Remove damaged latch assembly (1) by drilling out rivet(2) using a No. 11 drill bit (0.191 dia.).b.Install new latch assembly (1) with a 3/16 inch dia.rivet (2) using hand riveter.5-18.CATCHREPLACEMENT.The following procedures are typical for replacement of allaccess door catch assemblies.Figure 5-12 (Illustration B) showsa typical catch assembly replacement using the left panel as anexample.a.Remove damaged catch assembly (1) by drilling outrivets (2) using a No. 11 drill bit (0.191 dia.).b.Install new catch assembly (1) with four 3/16 inch dia.rivets (2) using hand riveter.5-19.RUBBERFLAPREPLACEMENT.The following procedures are for replacement of all rubber flaps.Figure 5-12 (Illustration C) shows a rubber flap replacementusing the rear flap assembly as an example.a.Remove rubber flap (1) (and retainer(s) if provided)from panel, support, or angle (2) by removing screws (3), washers(4) and nuts (5) (or by drilling out rivets using a No. 11 drillbit, 0.191 dia.).Save retainer(s) (if provided) for reuse.b.Use old rubber flap as a pattern to cut a new flap frombulk material and to mark new holes in flap for rivets or screws.c.Drill out holes for rivets or screws in new rubberflap.Use No. 11 (0.191 dia.) drill bit for rivet holes.d.Install new rubber flap (1) (with old retainer(s) ifprovided) on panel, support, or angle (2) with same number ofscrews (3), washers (4) and nuts (5) (or 3/16 inch dia. rivetsusing hand riveter).Change 85-27
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business