TM 5-6115-585-12
NAVFAC P-8-623-12
TO 35C2-3-455-1
TM-05684C/05685B-12
SECTION III.
ACOUSTIC SUPPRESSION KIT REPAIR
5-15.
GENERAL.
The local safety office and Preventative Medicine
Support Activity must be consulted prior to initial
CARC painting.
This section provides repair procedures for the Acoustic Suppres-
sion Kit (ASK).
Repair of the ASK at all levels of Maintenance
is limited to replacement of panel assemblies and replacement of
hinges, latches, catches, captive nuts, rubber flaps and the
front panel silencer assembly.
After repair is accomplished,
paint needed areas in accordance with MIL-STD-704 using paints
colors green 383, brown 383, and black as required by FED-
STD-595.
5-16.
REPLACEMENT OF ASK COMPONENTS.
a.
Refer to Table 3-2 for inspection of ASK components for
damage and to determine if replacement is necessary.
b.
Remove the ASK component to be replaced by following
the applicable removal procedures outlined in Section II.
c.
Prior to replacement of the rear panel, left support,
right support, side closure and rear closure assemblies, adhesive
backed teflon tape must be applied to the new assemblies as
follows:
(1)
Rear Panel Assembly (refer to figure 5-6, item 4).
(a)
Wipe surface clean.
(b)
Cut a 11 3/4 in. length of adhesive backed
teflon tape from supplied bulk material.
(c)
Apply adhesive backed teflon tape to the
right edge of rear panel assembly (edge with captive nuts).
Use
hand pressure to remove air bubbles.
(d)
Clear tape from captive nut openings.
(2)
Left Support Assembly (refer to figure 5-7,
item 9).
(a)
Wipe surface clean.
(b) Cut a 61 in. length of adhesive backed teflon
tape from supplied bulk material.
Change 8
5-25