EXHAUST PLENUM ASSEMBLY

Figure 5-6. Rear Panel Assembly, Removal and Installation

Figure 5-7. Left Support Assembly, Removal and Installation

TM-5-6115-585-12 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 KW 1 Phase 2 Wire 1 Phase-3 Wire 3 Phase-4 Wire 120 120/240 and 120/208 Volts Manual
Page Navigation
138

TM 5-6115-585-12 NAVFAC P-8-623-12 TO 35C2-3-455-1 TM-05682C/05685B-12 (3) Install two screws (1) and washers (2) securing right panel assembly (3) to rear panel assembly (4). (4) Torque screws (1) to 18 ±2 in.-lbs dry. 5-8. EXHAUST PLENUM ASSEMBLY. a. Removal. See figure 5-3. Remove assembly from shutter assembly as follows: (1) Remove top panel assembly (3) paragraph 5-4. exhaust plenum as described in (2) Remove four screws (13) and locknuts (14), and eight washers (15 and 16) securing exhaust plenum assembly (17) to shutter assembly (18) and lift off exhaust plenum assembly (17). b. Installation. See figure 5-3. Install exhaust plenum assembly on shutter assembly as follows: (1) Position exhaust plenum assembly (17) on shutter assembly (18) and install four screws (13) and locknuts (14), and eight washers (15 and 16) securing exhaust plenum assembly (17) to shutter assembly (18). (2) Torque screws (13) to 16 ±2 ft-lbs dry. (3) Install top panel assembly (3) as described in paragraph 5-4. 5-9. LEFT SUPPORT ASSEMBLY. a. Removal. See figure 5-7. Remove left support assembly from skid as follows: (1) Remove four screws (1) and washers (2) securing access plate (3) to AC output control box (4). (2) Remove top panel assembly (5), as described in paragraph 5-4. (3) Remove left panel assembly (6) with side closure assembly (7) as described in paragraph 5-5. (4) Loosen four screws (8) and slide out left support assembly (9) from under skid (10). b. Installation. See figure 5-7. Install left support assembly onto skid as follows: (1) With four screws (8) loosened, slide left support assembly (9) between skid (10) and bevel washers (11). 5-16 Change 8

Privacy Statement
Press Release
Contact