TM 5-6115-585-12
NAVFAC P-8-623-12
TO 35C2-3-455-1
TM-05682C/05685B-12
b.
Installation.
See figure 5-5.
Install right panel
assembly to right support assembly, front panel assembly, top
panel assembly, rear closure assembly and rear panel assembly as
follows:
(1)
Position right panel assembly (3) on right support
assembly (4) and install two screws (11) and locknuts (12), and
four washers (13 and 14) securing right panel assembly (3) to
rear closure assembly (15) and install two screws (16) and
washers (17) securing right panel assembly (3) to rear panel
assembly (18).
(2)
Torque screws (11) to 16 ±2 ft-lbs dry.
(3) Torque screws (16) to 18 ±2 in.-lbs dry.
(4)
Install five screws (8) and washers (9) securing
right panel assembly (3) to top panel assembly (10).
(5)
Torque screws (8) to 18 ±2 in.-lbs dry.
(6)
Install three screws (5) and washers (6) securing
right panel assembly (3) to front panel assembly (7).
(7)
Torque screws (5) to 18 ±2 in.-lbs dry.
(8)
Install six screws (1) and washers (2) securing
right panel assembly (3) to right support assembly (4).
(9)
Torque screws (1) to 18 ±2 in.-lbs dry.
5-7.
REAR PANEL ASSEMBLY.
a.
Removal.
See figure 5-6.
Remove rear panel assembly
from control cubicle support frame and right panel assembly as
follows:
(1) Remove two screws (1) and washers (2) securing
right panel assembly (3) to rear panel assembly (4) and remove
rear panel assembly (4).
(2) Remove four screws (5) and locknuts (6), and eight
washers (7 and 8) securing rear panel assembly (4) to control
cubicle support frame (9).
b.
Installation.
See figure 5-6.
Install rear panel
assembly to control cubicle support frame and right panel
assembly as follows:
(1) Position rear panel assembly (4) on control
cubicle support frame (9) and install four screws (5) and
locknuts (6), and eight washers (7 and 8) securing rear panel
assembly (4) to control cubicle support frame (9).
(2)
Torque screws (5) to 16 ±2 ft-lbs dry.
5-14
Change 8
