TM 5-6115-585-12
NAVFAC P-8-623-12
TO 35C2-3-455-1
TM-05682C/05685B-12
b.
Installation.
See figure 5-4.
Install left panel with
side closure assembly to top panel, front panel, left support and
rear closure assemblies as follows:
(1)
Install three screws (15) and locknuts (16) and
six washers (17 and 18) securing side closure assembly (13) to
left panel assembly (4).
(2)
Torque screws (15) to 16 ±2 ft-lbs dry.
(3)
Position left panel assembly (4) with side closure
assembly (13) on generator and install two screws (9) and lock–
nuts (10) and four washers (11 and 12) securing side closure
assembly (13) to rear closure assembly (14).
(4)
Torque screws (9) to 16 ±2 in.-lbs dry.
(5)
Install three screws (6) and washers (7) securing
left panel assembly (4) to front panel assembly (8).
(6)
Torque screws (6) to 18 ±2 in.-lbs dry.
(7)
Install four screws (2) and washers (3) securing
left panel assembly (4) to left support assembly (5).
(8)
Torque screws (2) to 18 ±2 in.-lbs dry.
(9)
Install top panel assembly (1) as described in
paragraph 5-4.
5-6.
RIGHT PANEL ASSEMBLY.
a.
Removal.
See figure 5-5.
Remove right panel assembly
from right support assembly, rear panel assembly, front panel
assembly, top panel assembly and rear closure assembly as
follows:
(1)
Remove six screws (1) and washers (2) securing
right panel assembly (3) to right support assembly (4).
(2)
Remove three screws (5) and washers (6) securing
right panel assembly (3) to front panel assembly (7).
(3)
Remove five screws (8) and washers (9) securing
right panel assembly (3) to top panel assembly (10).
(4) Remove two screws (11) and two locknuts (12), and
four washers (13 and 14) securinq riqht panel assembly (3) to
rear closure assembly (15) and remove
(17) securing right panel assembly (3)
(18) and remove right panel asssembly
5-12
Change 8
two screws (16)and washers
to rear panel assembly
(3) .
