Exhaust Plenum Assembly - TM-5-6115-584-34

Figure 10-3. Installation of Rear and Side Closure and Exhaust Plenum Assemblies

Figure 10-4. Installation of Right Panel Assembly

TM-5-6115-584-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
139

TM5-6115-584-34 NAVFAC P-8-622-34 TO 35C2-3-456-2 TM 05682C-34 Apply adhesive backed teflon tape to a clean top edge (surface which will mount against top panel assembly) and left edge (edge with three holes) of side closure assembly (9). Use hand pres- sure to remove air bubbles. Clear teflon tape away from screw holes. (2) Refer to figure 10-3 and locate side closure assembly (9) over fuel tank (10). Align side closure assembly mounting holes (11) with rear closure assembly mounting holes (12). (3) Install side closure assembly (9) to rear closure assembly (1) with two screws (13), four washers (14 and 15) and two locknuts (16) (as listed in Table 10-1, item 6) (4) Torque screws (13) to 16 ±2 ft-lbs dry. g . Exhaust Plenum Assembly. (1) Refer to figure 10-3 and install exhaust elbow (17) (as listed in Table 10-1, item 7) to generator exhaust (18) . Point elbow opening downward (exhaust down). (2) Install hose (19) over sleeve (20) at bottom of exhaust plenum (21). Install clamp (22) over hose (19) and sleeve (20). (3) Install exhaust plenum assembly (21) over exhaust shutter assembly (23) until rear upper channel of plenum is flush with exhaust shutter assembly (23). Screws (24) in exhaust shutter assembly (23) fit into plenum slots. (There is a 1-7/8” overlap.) Using exhaust plenum assembly (21) as template, mark mounting holes (25) and drill four 5/16 inch holes in exhaust shutter assembly (23). (4) Install exhaust plenum assembly (21) to exhaust shutter assembly (23) with four screws (26), eight washers (27 and 28) and four locknuts (29) (listed in table 10-1, item 7.) (5) Torque screws (26) to 16 ±2 ft-lbs dry. (6) Route drain hose (19) between batteries and engine block. h. Right Panel Assembly (Long Side). (1) Refer to figure 10-4 and clear out acoustic fill from holes in right panel assembly (1) using 3/8 inch diameter pin. (2) Locate right panel assembly (1) on right support assembly (2) by aligning captive nuts (3) in right panel assembly (1) with holes in right support assembly (2). Align captive nuts (4) in rear panel assembly (5) with holes in right panel assembly (1). Align holes in rear closure assembly (6) with holes in right panel assembly (1). 10-10 Change 6

Privacy Statement
Press Release
Contact