POST INSTALLATION PROCEDURES

Figure 10-5. Installation of Left Panel, Front Panel and Top Panel Assemblies

TM-5-6115-584-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
143

TM5-6115-584-34 NAVFAC P-8-622-34 TO 35C2-3-456-2 TM 05682C-34 (2) Locate top panel assembly (16) by aligning holes in top panel assembly (16) with captive nuts in left panel assembly (2), right panel assembly (13) and front panel assembly (12), and with holes in side closure assembly (5) and rear closure assembly (17). (3) Install top panel assembly (16) to left panel assembly (2), right panel assembly (13) and front panel assembly (12) with eleven screws (18) and eleven washers (19). Install top panel assembly (16) to side closure assembly (5) and rear closure assembly (17) with seven screws (20), 14 washers (21 and 22) and seven locknuts (23) (as listed in Table 10-1, item 11). (4) Torque screws (18) to (5) Torque screws (20) to 1 0 - 5 . POST INSTALLATION PROCEDURES. WARNING 18 ± 2 in.-lbs dry. 16 ±2 ft-lbs dry. The local safety office and Preventative Medicine Support Activity must be consulted prior to initial CARC painting. Inspect ASK and generator set for any areas where touch-up painting may be required. Perform necessary touch-up painting in accordance with MIL-T-704 using paint colors green 383, brown 383, and black as required by FED-STD-595. 10-14 Change 6

Privacy Statement
Press Release
Contact