Left Panel Assembly (Short Side)

Figure 10-4. Installation of Right Panel Assembly

Figure 10-5. Installation of Left Panel, Front Panel and Top Panel Assemblies

TM-5-6115-584-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
141

TM5-6115-584-34 NAVFAC P-8-622-34 TO 35C2-3-456-2 TM 05682C-34 assembly (2) with five screws (7) and five washers (8). Install right panel assembly (1) to rear closure assembly (6) with two screws (9), four washers (10 and 11) and two locknuts (12). Install right panel assembly (1) to rear panel assembly (5) with two screws (13) and two washers (14) (listed in table 10-1, item 9. (4) Torque screws (13) and screws (7) to 18 ±2 in.- lbs dry. (5) Torque screws (9) to 16 ±2 ft-lbs dry. i. Left Panel Assembly (Short Side). (1) Refer to figure 10–5 and install battery terminal covers (1) (listed in Table 10-1, item 8). Disconnect cable clamps from battery terminals. Place 4 each terminal covers (1) over battery terminals (2 red terminal covers for positive bat- tery terminals and 2 black terminal covers for negative battery terminals). Reconnect cable clamps to battery terminals. Cover cable clamps with terminal covers (1). (2) Clear out acoustic fill from holes in left panel assembly (2) using 3/8 inch diameter pin. (3) Locate left panel assembly (2) on left support assembly (3) by aligning captive nuts (4) in panel with holes in left support assembly (3). (4) Install left panel assembly (2) to side closure assembly (5) with three screws (6), six washers (7 and 8) and three locknuts (9) and to left support assembly (3) with three screws (10) and three washers (11) (listed in table 10-1, item 8.) (5) Torque screws (10) to 18 ±2 in.-lbs dry. (6) Torque screws (6) to 16 ±2 ft-lbs dry. j. Front Panel Assembly (1) Refer to figure 10-5 and clear out acoustic fill from holes in front panel assembly (12) using 3/8 inch diameter pin. (2) Install front panel assembly (12) to right panel assembly (13) and left panel assembly (2) with six screws (14) and six washers (15) (as listed in table 10-1, item 10). Start all screws by hand first. (3) Torque screws (14) to 18 ±2 in.-lbs dry. k. Top Panel Assembly. (1) Refer to figure 10-5 and clear out acoustic fill from holes in top panel assembly (16) using 3/8 inch diameter pin. 10-12 Change 6

Privacy Statement
Press Release
Contact