TM5-6115-584-34NAVFAC P-8-622-34TO 35C2-3-456-2TM 05682C-34d.Rear Flap Assembly.(1)Refer to figure 10-1 and using rear flap assembly(19) as template, center assembly on skid resting flap assemblyangle on top of skid (2).Mark mounting hole locations and drillthree 5/16 inch holes (20) into skid (2).(2)Install rear flap assembly (19) to skid (2) withthree screws (21), six washers (22 and 23) and three locknuts(24) (as listed in table 10-1, item 4.)(3)Torque screws (21) to 16 ±2 ft-lbs dry.e.Rear Closure Assembly.(1)Refer to Operator and Organizational MaintenanceManual paragraph 3-18 and remove air cleaner assembly.CAUTIONWhen drilling holes care must be taken notto damage control cubicle.(2)Refer to figure 10-3 and locate rear closureassembly (1) behind mounting brackets (3).Seat clips (3A) ofrear closure assembly (1) over mounting brackets (3) , so thatrear closure assembly (1) is positioned over vibration mount hard-ware. When positioned correctly, the rear closure assembly (1) is1/4 inch higher than top of control cubicle (2).Using rearclosure assembly (1) as template, mark and drill four 5/16 inchholes in mounting brackets (3).(3)Cut a 23 in. length and a 14 in. length ofadhesive backed teflon tape (listed in Table 10-1, item 5) .Apply adhesive backed teflon tape to a clean top edge (edge withthree holes) and right edge (edge with two holes which willcontact right panel assembly) of rear closure assembly (1).Usehand pressure to remove air bubbles.Clear tape from holes.(4)Install rear closure assembly (1) to controlcubicle support (3) with four screws (5), eight washers (6 and7), and four locknuts (8) (as listed in Table 10-1, item 5).(5)Torque screws (5) to 16 ±2 ft-lbs dry.(6)Refer to Operator and Organizational MaintenanceManual, paragraph 3-18, and replace air cleaner assembly removedin step e.(l).f.Side Closure Assembly.(1)Cut a 20 1/2 in. length and a 29 1/4 in. lengthof adhesive backed teflon tape10-8Change 6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
