HINGES

Figure 5-13. Replacement of ASK Hardware Items

APPENDIX A REFERENCES - TM-5-6115-584-12_194

TM-5-6115-584-12 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
148

TM 5-6115-584-12 NAVFAC P-8-622-12 TO 35C2-3-456-1 TM-05682C-12 5-20. HINGES . The following procedures are for hinge replacement on the top panel assembly access door. See figure 5-13. (Illustration D). a. Remove hinge (1) from panel assembly (2) and access door (3) by drilling out rivets (4 and 5) using a No. 11 drill bit (0.191 dia.). b. Install hinge (1) to access door (3) and panel assembly (2) with same number of 3/16 inch dia. rivets (4 and 5) using hand riveter. 5-21. CAPTIVE NUTS. The following procedures are typical for replacement of captive nuts installed in the left and right panel assemblies, rear panel assembly, and front panel assembly. See figure 5-13 (Illu- stration E) showing an example for replacement of captive nuts. a. Remove captive nut (1) from panel (2) by squeezing sides of cage with pliers. Pull out until nut is freed. b. Install new captive nut (1) by squeezing sides of cage with pliers until nut can be inserted into square opening in panel . 5-22. FRONT PANEL SILENCER. The following procedures are to be followed for replacement of the silencer attached to the front panel. See figure 5-13 (Illustration F). a. Remove nine rivets (1) securing silencer (2) to front panel (3) by drilling out rivets using a No. 11 drill bit (0.191 dia.). b. Apply adhesive backed teflon tape to all four inside edges of new silencer. Clear tape from rivet hoses. Locate silencer on front panel by aligning rivet holes. c . Install new silencer (2) to front panel (3) with nine 3/16 inch dia. rivets (1) using hand riveter. 5-30 Change 7

Privacy Statement
Press Release
Contact