TM 5-6115-584-12
NAVFAC P-8-622-12
TO 35C2-3-456-1
TM-05682C-12
d.
Install ASK replacement components by following the
applicable installation procedures outlined in Section II.
5-17. LATCH REPLACEMENT.
The following procedures are for replacement of side closure door
latch assemblies.
Figure 5-13 (Illustration A) shows a typical
latch assembly replacement.
a.
Remove damaged latch assembly (1) by drilling out rivet
(2) using a No. 11 drill bit (0.191 dia.).
b.
Install new latch assembly (1) with a 3/16 inch dia.
rivet (2) using hand riveter.
5-18.
CATCH REPLACEMENT.
The following procedures are typical for replacement of all
access door catch assemblies.
Figure 5-13 (Illustration B) shows
a typical catch assembly replacement using the left panel as an
example.
a.
Remove damaged catch assembly (1) by drilling out
rivets (2) using a No. 11 drill bit (0.191 dia.).
b.
Install new catch assembly (1) with four 3/16 inch dia.
rivets (2) using hand riveter.
5-19.
RUBBER FLAP REPLACEMENT.
The following procedures are typical for replacement of all
rubber flaps.
Figure 5-13 (Illustration C) shows a rubber flap
replacement using the rear flap assembly as an example.
a.
Remove rubber flap (1) (and retainer(s) if provided)
from panel, support, or angle (2) by removing screws (3), washers
(4) and nuts (5) (or by drilling out rivets using a No. 11 drill
bit) .
Save retainer(s) (if provided) for reuse.
b.
Use old rubber flap as a pattern to cut a new flap from
bulk material and to mark new holes in flap for rivets or screws.
c.
Drill out holes for rivets or screws in new rubber
flap.
Use No. 11 (0.191 dia.) drill bit for rivet holes.
d.
Install new rubber flap (1) (with old retainer(s) if
provided) on panel, support, or angle (2) with same number of
screws (3), washers (4) and nuts (5) (or 3/16 inch dia. rivets
using hand riveter).
5-28
Change 7
