REAR FLAP ASSEMBLY - TM-5-6115-584-12

Figure 5-11. Rear Closure Assembly, Removal and Installation

Figure 5-12. Rear Flap Assembly, Removal and Installation

TM-5-6115-584-12 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
142

TM 5-6115-584-12 NAVFAC P-8-622-12 TO 35C2-3-456-1 TM-05682C-12 (4) Remove four screws (13) and locknuts (14), and eight washers (15 and 16) securing rear closure assembly (6) to mounting brackets (17) and remove rear closure assembly (6). b. Installation. See figure 5-11. Install rear closure assembly to control box support, side closure assembly, right and top panel assemblies as follows: (1) Install four screws (13) and locknuts (14), and eight washers (15 and 16) securing rear closure assembly (6) to mounting brackets (17). (2.) Tighten screws (13) to 16 ±2 ft-lbs dry. (3) Install two screws (8) and locknuts (9), and four washers (10 and 11) securing side closure assembly (12) to rear closure assembly (6). (4) Torque screws (8) to 16 ±2 ft-lbs dry. (5) Install two screws (2) and locknuts (3) and four washers (4 and 5) securing rear closure assembly (6) to right panel assembly (7). (6) Torque screws (2) to 16 ±2 ft–lbs dry. (7) Install top panel assembly (1) as described in paragraph 5-4. 5-14. REAR FLAP ASSEMBLY. a. Removal. See figure 5-12. Remove rear flap assembly from skid as follows: (1) Remove three screws (1) and locknuts (2), and six washers (3 and 4) securing rear flap assembly (5) to skid (6). (2) Remove rear flap assembly (5). b. Installation. See figure 5-12. Install rear flap assembly to skid as follows: (1) Position rear flap assembly (5) on skid (6) and install three screws (1) and locknuts (2), and six washers (3 and 4). (2) Torque screws (1) to 16 ±2 ft-lbs dry. 5-24 Change 7

Privacy Statement
Press Release
Contact