Figure 4-34. Removing Control Cubicle Support Assembly

Figure 4-35. Control Cubicle Test Set-Up - TM-5-6115-584-12_147

TM-5-6115-584-12 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
102

TM 5-6115-584-12 NAVFAC P-8-622-12 TO-35C2-3-456-1 TM-05682C-12 Figure 4-34. Removing Control Cubicle Support Assembly (3) Battery Charging Indicator (M1). Tag and disconnect lead to indicator. Remove two lockwashers and nuts and retainer holding meter in place and remove indicator. (4) DC Control Circuit Breaker (CB2). Discon- nect two leads to breaker. Remove two screws attaching breaker to control panel and remove breaker. (5) Master Switch (S1). Disconnect battery. Tag and disconnect seven leads to master switch. Re- move switch knob by loosening two setscrews. Remove nut attaching switch to control panel and remove switch. (6) Panel Light Switch (S2). Tag and disconnect two leads to switch. Remove nut attaching switch to control panel and remove switch. (7) Ammeter - Voltmeter Transfer Switch (S8). Tag and disconnect sixteen leads to range selector switch. Remove switch knob by loosening two setscrews. Remove nut attaching switch to control panel and remove switch. Install new switch as given above. (8) Voltage Adjust Rheostat (R1). Tag and dis- connect two leads to rheostat. Remove rheostat knob by loosening two allen setscrews. Remove nut and washer attaching rheostat to panel and remove rheostat (9). (9) Transformer (T1). Tag and disconnect five leads to transformer. Remove four screws and lockwashers attaching transformer to control cubicle and remove transformer. (10) Transformer (T2). Tag and disconnect four leads to transformer. Remove two screws and lock- washers attaching transformer to cubicle and remove transformer. Change 3 4-43

Privacy Statement
Press Release
Contact