Figure 14-28. Crankshaft Pulley and Related Parts

Section XI. CRANKSHAFT PULLEY AND VIBRATION DAMPENER, AND ENGINE FRONT SUPPORT

TM-5-6115-545-34 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
287

1. Screw 2. Washer 3. Pulley ME 6115-545-34/14-28 4. Key Figure 14-28. Crankshaft Pulley and Related Parts NOTE h. If original washers do not satisfy this re- Do not tighten at this time. quirement, remove capscrews and install shimming washers to equal the gap. f . Lower engine into position on bracket and install exact number of washers as noted during re- moval and install bracket cap and securing capscrews. g. Tighten bracket cap securing capscrews evenly to a torque of 95 to 105 foot-pounds. Deter- mine the amount of shimming washers necessary to fill the gap between ends of the bracket and cap. NOT E i. Install capscrews and torque to 95 to 105 foot-poundsl CAUTION The bracket assembly tight fit on trunnion to ment of liners. must be a avoid move - Shimming washers are 1/32 inch thick and must be evenly distributed on both sides of bracket. 14-63

Privacy Statement
Press Release
Contact