Section IV. OPERATOR’S MAINTENANCE3-8. General.3-10. Slave Receptacle Inspection.Instructions in this section are provided to assist theA slave receptacle (17, fig. 3-4) is located in aoperator in maintaining the engine generator set.receptacle box on the forward left side of the housing.Inspect the slave receptacle for loose mounting,3-9. Batteries.loose electrical connections, loose covers, corrosionand other damage.a.Inspection.See figure 3.4 and remove screws(9),and washers (10) and studs (8) which attach bat-3-11. Muffler, Exhaust Pipe and Breather System Inspectiontery tray (11) to base and slide storage batteries andInspect muffler and exhaust pipes (fig.3-12) and breathertrays (11) out. Inspect storage batteries for crackssystem (Fig. 3-12.1) for crocks, leaks, breaks, loose mounting,and leaks. Check for loose cables (1, 2 and 3) andand other damage.mountings and excessive corrosion.3-12. Convenience Receptacle Assemblyb. Service.Refer to table 3-1. Fill to 3/8 inchInspection.above plates. In freezing weather, run engine a mini-mum of 1 hour after adding distilled water. ApplyInspect convenience receptacles assemblygrease to cable connectors.and components for loose mounting, loosecorrosion and other damage.(fig. 3-13)covers,Change 123 - 6 . 1 / ( 3 - 6 . 2 b l a n k )
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
