P-8-627-34
T
O
35C2-3-442-2
TM-07464A-35
T M 5-6115-457-34
h. Remove hydraulic pump drive group
CAUTION
Use extreme care when removing
camshaft from engine block so
i . Remove crankshaft pulley, damper,
a n d timing gear cover group (para-
that camshaft bearings will not be
damaged by cam lobes passing
graph 8-126).
through bearings. Do not rotate
crankshaft with camshaft gear
j . Removal of the camshaft group is
removed.
accomplished during disassembly (para-
8 - 2 0 7 . CLEANING.
graph 8-206).
Clean components with an approved
8 - 2 0 6 . DISASSEMBLY.
cleaning solvent and dry thoroughly.
8 - 2 0 8 . INSPECTION.
Refer to figure 8-61 and disassem-
a. Refer to table 1-1 and, using a
ble camshaft group in the order of index
suitable micrometer and feeler gauge,
numbers assigned. Pay particular atten -
check for excessive wear as follows:
tion to the following:
1. Camshaft bearing journal
WARNING
diameter.
Cleaning Solvents are flammable and
2 . Camshaft end clearance.
moderately toxic to skin, eyes and
respiratory tract. Eye and skin
3. If allowable limits are not met,
protection required. Good general
replace part.
ventilation is normally adequate.
Camshaft group, exploded view
Figure 8-61.
Legend to figure 8-61:
5. Lock
1. Bolt (4)
6. Washer
2. Lock
7. Camshaft
3. Gear
4. Bolt (2)
8-127
Change 8
