P-9-TM-457-35 T.O. 35C2-3-442-2
TM-07464A-35
TM 5-6115-457-34
Operating under manual control, the
index numbers assigned. Pay particular
pressure at port Al should be 18020
attention to the following.
PSI and approximately 50 PSI higher than the
pressure at port A2.
1. Disconnect harness plug from
governor actuator unit before removing
5. Check the transducer in the
from engine.
actuator for freedom of movement, Trans-
ducer must move freely for good response.
2. Plug hydraulic lines after re-
moval.
6. If any of the above examinations
indicates that the actuator has failed, pro-
8-110. DISASSEMBLY.
ceed with removal, disassembly and repair
instructions.
Refer to figure 8-26 and disassemble
governor actuator unit in the order of index
b. Removal. Refer to figure 8-25 and
numbers assigned. Pay particular attention
remove governor actuator unit in order of
to the following.
Figure 8-25. Governor actuator unit, removal and installation (precise sets only)
8-54
