T.O. 35C2-3-442-2
P-9-TM-457-35
TM 5-6115-457-34
TM-07464A-35
2. Preheat gear (21) to a maximum
h. Discard seal, gasket and lockring.
of 600F
q
i. Check tang drive end of shaft. Slot
3. Using a suitable arbor press,
in shaft should be 0.253 to 0.257 inch wide.
press gear (21) onto shaft (23).
Replace shaft if slot is not within limits.
b. Hand pack bearing (20) with an ap-
proved grease. Press bearing into adapter
8-105, REPAIR.
(14) .
a. Remove minor nicks and burrs using
c . Lubricate seal lip of seal (16) with
a suitable file or hone.
an approved lubricant before installing on
shaft (23) .
b. Repair minor thread damage using
d. Locate oil drain hole in end adapter
a suitable thread chaser.
(14). Drain hole must be pointed downward
when drive is mounted in gear cover.
8-106. REASSEMBLY .
8-107. INSTALLATION.
Refer to figure 8-24, and reassem-
ble hydraulic pump drive group in the re-
verse order of index numbers assigned.
a. Refer to figure 8-24 and install the
Pay particular attention to the following:
hydraulic pump drive group, secure with
bolts (1 and 4), nuts (2 and 5), lock washers
a. If removed, install gear (21) and
(3 and 6) and gasket (7).
bearing (22) on shaft (23) as follows:
b. Refer to paragraph 8-99 and install
1. Hand pack bearing (22) with an
approved grease. Install bearing onto
hydraulic pump (precise generator sets
only).
shaft (23) .
8-51
Change 1
