P-8-627-34
T O 35C2-3-442-2
TM-07464A-35
TM 5-6115-457-34
1. Atomizer tube, atomizer and
10. Alternator assembly.
bushing.
11. Alternator and fan drive belts.
2.
Hydraulic filter (precise sets
only).
e. Connect all hydraulic and fuel lines
to engine.
3. Breather assembly.
f. Refer to Operator and Organizational
4. Secondary fuel filter and relief
Maintenance Manual and adjust fan and
valve.
alternator belts, valve lash, and utility
governor linkage. Service the engine and
Lubricating oil filters.
5,
components.
INSTALLATION.
8-5.
6. Starter motor.
NOTE
7. Fuel filter and pump assembly,
If a complete overhaul or any major
threaded spacers and adapter.
repair has been performed on the
engine, refer to Section XXXI for
engine test after overhaul.
8. Manual speed controls.
Refer to paragraph 2-8 and install
9. Fuel day tank
the engine group.
Section II. ENGINE HARNESS GROUP
Maintenance Manual and remove the engine
8-6.
GENERAL.
wiring harness.
The engine wiring harness provides
8-8.
CLEANING.
for electrical interconnection between the
engine accessories and mode I or mode II
a. Clean wires with a clean lint free
relay box. The harness is connected to
cloth.
connector J5 of the mode I or mode H relay
box (A27), J14 of high coolant temperature
WARNING
switch, J33 of day tank float switch, J35 of
air cleaner indicator switch, J36 of day tank
Compressed air used for cleaning and
drying purposes can create airborne
solenoid valve, J37 of speed switch, J38 of
particles that may enter the eyes.
ether starting aid primer, J39 of DC con-
Pressure shall not exceed 30 psig.
trol circuit breaker, J42 of low oil pressure
Eye protection is required.
switch, J43 of alternator, two oil pres-
sure transmitters, collant temperature
transmitter, fuel level transmitter, fuel
b. Remove dirt from connector pins
transfer pumps, engine shutdown solenoid
using low pressure compressed air.
valve, starter, and starter solenoid.
INSPECTION.
8-9.
8-7.
REMOVAL.
a. Inspect wiring for defective insula-
Refer to Operator and Organizational
tion, continuity, and proper connection.
8-2
Change 8
