TO 35C2-3-442-2
Table 6-13. Mode II Relay Box Assembly (A27) Continuity Test (Continued)
a. Remove ten screw assemblies (2,
d. Remove underfrequency relay (K12),
undervoltage relay (K11) and permissive
(1) from chassis assembly (39).
paralleling relay (K16) by removing their
attaching screws (4 each).
b. Tag, then disconnect harness wiring
NOTE
from components.
Refer to paragraphs 6-106, 6-110,
and 6-114 respectively for relay
c. Remove battery charging ammeter
maintenance instructions.
shunt (R13 ) , engine crank ing relay (K3),
transformer (T1) and resistor (R1), b y
e. Remove dc control relay assembly
removing their attaching screws and nuts
(A5) by removing the four nuts securing
(2 each). See figure 6-22.
the assembly in position.
6-95
Change 11
