T.O. 35C2-3-442-2
P-9-TM-457-35
TM 5-6115-457-34
TM-07464A-35
Legend to figure 6-34:
21.
Screw assembly (8)
1.
Cover
22.
2.
Nut assembly (8)
Screw assembly (10)
23.
Wiring harness
3.
Washer (10)
24.
4.
Nut
Screw assembly (6)
25.
Washer (6)
5.
Washer
26.
Terminal board jumper (13)
6.
Rheostat (R29)
27.
Nut
7.
Terminal board assembly
28.
8.
Screw assembly (8)
Washer
29.
9.
Nut assembly (8)
Rheostat (R28)
30.
10.
Terminal board (4)
Electrical connector cover
31.
11.
Electrical connector cover
Bracket
32.
Screw assembly (16)
12.
Screw assembly (6)
33.
13.
Nut assembly (16)
Washer (6)
34.
Screw assembly (4)
14.
Electronic component assembly
15.
35.
Nut assembly (4)
Rivet
16.
36.
Screw assembly (3)
Identification plate
17.
37.
Screw assembly (8)
Rivet
18.
38.
Nut assembly (8)
Identification plate
19.
39,
Screw assembly (8)
Chassis assembly
20.
Nut assembly (8)
NOTE
h. Remove wire harness (23) by re-
moving the four screws and nuts securing
Refer to paragraph 6-86 for dc
each of the ten connectors to the chassis
relay assembly maintenance in-
assembly (39).
structions.
NOTE
f. Remove electronic components as-
sembly (A6) by removing the three screw
Electrical connector covers (10
assemblies securing the assembly in posi-
and 11) will fall free.
tion.
6-131. CLEANING. Clean all components
NOTE
with a clean lint-free cloth moistened in
an approved cleaning solvent and dry thor-
oughly.
Refer to paragraph 6-118 for elec-
tronic component assembly main-
tenance instructions.
6-132. INSPECTION.
a. Harness.
g. Remove nuts (4 and 7, figure 6-34)
and washers (5 and 8) securing rheostats
1. Inspect harness wiring for defec-
(6 and 9) to chassis assembly (39).
tive insulation and continuity.
Change 3
6-98
