T O 35C2-3-442-2
P-8-627-34
TM-07464A-35
TM 5-6115-457-34
Figure 2-6. Engine, removal and installation
b. Installation. Install the engine as
3. Inspect flywheel for nicks and
follows:
burrs on generator contact surfaces.
Remove nicks and burrs using a suitable
1. Move engine as close to generator
file or stone. Clean flywheel with an
set as possible.
approved cleaning solvent and dry
2. Connect a suitable lifting device
thoroughly.
to both engine lifting eyebolts (figure 2-6).
WARNING
4. Insert spacers (12 and 14, fig-
ure 2-5) and spring washer (13) in flywheel.
Cleaning Solvents are flammable and
moderately toxic to skin, eyes and
5. Inspect generator shaft couplings
respiratory tract. Eye and skin
for ragged edges and burrs. Touch up
protection required. Good general
ragged edges and burrs with a suitable file,
ventilation is normally adequate.
exercising care to remove burrs and
love nicks and burrs using a suitable
ragged edges only, Clean shaft couplings
2-14
Change 8
