T O 35C2-3-442-2
P-8-627-34
TM 5-6115-457-34
TM-07464A-35
WARNING
screws (2). Remove nuts (11 and 17),
screws (13 and 18), and washers (12 and
19). Move reconnection board assembly
Stay clear of engine during lifting.
(20) away from bracket (16).
CAUTION
During lifting operations, check
9. Disconnect screen (4, figure 2-5)
that generator mounting bolts are
by removing nuts (l), washers (2), and
not binding on generator mount.
screws (3).
15. Slowly raise lifting device, pivot-
ing f rent of engine up until there is suffi-
10. Disconnect auxiliary fuel hose
cient clearance for engine oil pan to clear
and mount from skid base at left rear of
engine support.
generator by removing screws and nuts.
-
16. Support f rent of engine to prevent
it from swinging forward when generator to
CAUTION
flywheel housing bolts are removed.
CAUTION
Rotate engine crankshaft as re-
Generator must be blocked so that
quired to gain access to screws.
generator weight is on skid base.
Do not attempt to rotate gen-
erator by prying on generator fan
17. Block generator in raised
posi-
or flywheel ring gear.
tion with suitable blocks that contact
each
side of the skid base.
11. Straighten corners of locking
18. Remove screws (9, figure
plates (6) and remove screws (5) and lock-
and washers (10) securing generator
to fly-
ing plates. Rotate engine using a suitable
wheel housing.
barring tool on crankshaft pulley bolt.
WARNING
Turn engine clockwise (standing in front of
Stay clear of engine during lifting.
engine looking toward generator) as
required for access to screws (5). Hold
barring tool stationary to permit loosening
19. Remove support from
front of
screws.
engine and move engine free of
generator.
Remove engine from generator
set. Place
engine on stand, cradle, or crib
and block.
12. Remove nuts (7) and washers (8)
and permit generator mounting bolts to rest
20. If necessary, remove spacers
on fuel tank.
(12 and 14) and spring washer (13) from
flywheel.
13. Connect a suitable overhead lift-
WARNING
ing device to both engine lifting eyebolts
Steam cleaning creates hazardous
noise levels and severe bum and
device.
injury potential. Eye, skin and
ear protection required.
14. Disconnect engine trunion mount
21. Plug all engine openings and
from engine support by removing bolts
steam clean engine.
and washers.
2-13
Change 8
