T O 35C2-3-442-2
P-8-627-34
TM-07464A-35 TM 5-6115-457-34
(a) Connect three electrical
with screws (13 and 18), washers (12 and
19), and nuts (11 and 17). Install exciter
leads to radio suppression diode assembly.
regulator and stowage box and secure with
(b) Connect ether starting tube
screws (2) and nuts (l). Connect elec-
trical connectors to exciter regulator.
to atomizer at rear of cylinder head inlet
elbow.
(c) Connect engine harness to
16. Using a suitable lifting device,
connector J5 of mode I or mode II relay box,
connector J33 of day tank float valve, con-
base. Secure lifting frame to skid base
nector J38 of ether primer, connector J39
with sixteen screws, washers, and nuts.
of DC control circuit breaker, and fuel tank
fuel level send unit. Fasten harness to
17. On precise generator sets, posi-
other harness with tiedown straps.
tion governor control unit on lifting frame
and secure with four screws, washers, and
(d) If required, install winter-
nuts. Connect electrical connectors to gov-
ization kit heaters and coolant lines. Con-
ernor control unit and governor actuator.
nect kit harnesses to control boxes.
Connect harness to connector P8 on precise
relay box. Secure harness to other har-
(e) Install air cleaner.
nesses with tie down strap.
(f) Connect and adjust manual
18. Connect fuel filler hose to fuel
speed control.
tank and secure with clamp. Connect fuel
tank vent hoses to fuel filler neck. Connect
(g) Install radiator and shutter.
fuel hoses to fuel transfer valve, auxiliary
fuel inlet fitting, fuel supply outlet fitting,
day tank, and electric fuel transfer pump.
Clamp hose to lifting frame.
19. Connect engine block coolant
(i) Install front and rear housing
drain hose to skid base fitting and secure
with clamp.
compartment access doors. Connect muf-
fler clamps to front housing cover.
20. Connect engine oil drain hose to
engine oil drain valve.
(j) Connect starter ground cable
to skid base. Connect cables to slave
21. Connect four upper side housing
receptacle SR2. Install negative battery
members to lifting frame and secure eight
cable.
screws and washers. Connect two mem-
bers to rear housing and secure with four
(k) Service radiator, engine and
screws and washers.
on precise generator sets hydraulic tank.
(l) Start engine and bleed fuel
22. Refer to Operator and Organiza-
system and hydraulic system on precise
tional Maintenance Manual and perform the
generator sets.
following:
Change 8
2-16