TM 9-6115-668-13
1.
Place bottom resistor (20) on studs (21)
Tighten screws and stand offs on studs with torque wrench to the
torque value In table (Item G.2, appendix G).
2.
Secure bottom resistor (20) with two washers (17), two serrated lock washers (16), and two nuts
(15).
3.
Install cable 23 and tighten nut (18), install cable 4 and tighten nut (19).
4.
Install two standoffs (14).
5.
Place top resistor (13) on standoffs (14).
6.
Secure top resistor (13) with two washers (12), two serrated lock washers (11), and two nuts (10).
7.
Install cable 23 and tighten nut (9).
8.
Install cable 4 and tighten nut (8).
9.
Install cable 48 (6) with flat connector on terminal (7).
10. Stow prop (5) and close front panel (4).
11. Close flap (2).
4 - 1 2 0
