TM 9-6115-668-138.Pull ring (10) with colored plate (11) and housing (12), and sealing ring (13) out from front of frontpanel (4) and remove base (14) from rear of front panel (4).INSTALLATION1.2.3.4.5.6.7.NOTElnstallation procedure for pushbutton switch S101 (6), S18 (7), S20 (9)is the same as for pushbutton switch S7 (8), described below.Insert housing (12), sealing ring (13), colored plate (11), and ring (10) into front panel (4) from thefront and hold base (14) against front panel (4) from the back.Push housing (12), sealing ring (13), colored plate (11) and ring (10) into base (14) and secure tobase (14) by turning clockwise.Tighten screws (15) on base (14).Install contact block (17) on base (14).Reconnect cables to terminals (18, 19) of contact block (17), noting correct labeling and position.Stow prop (5) and close front panel (4).Close flap (2).4 - 1 1 5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
