TM 9-6115-668-13
4.46 PANEL ILLUMINATION H6 MAINTENANCE.
This task covers:
a. Removal
b. Installation
Tools
Equipment Conditions
General Mechanic’s Tool Kit
Reference
(item 2, appendix B)
Generator Set 150 kW shut
Automotive Fuel and Electrical System Repair, Tool Kit
down,
(item 3, appendix B)
paragraph 2.5.2
Disconnect the negative battery cable first and then the positive bat-
tery terminal cables. Failure to observe this warning could result In se-
vere personal Injury or death.
Tag all cables prior to removal to ensure correct connection of the
cables during Installation.
1.
Open flap (2, figure 4-47) on unit hood assembly (1).
2.
Open front panel (4) on control cabinet assembly (3) and secure with prop (5).
3.
Remove cover panel (6) from lamp base (11) of panel illumination H6.
4.
Disconnect cable from terminal (7) of bayonet socket (8) by loosening set screw.
5.
Pull bulb (9) with bayonet socket (8) to the right and out of lamp base (11).
6.
Tag and disconnect cables from terminals of lamp base (11).
7.
Remove two nuts (14), two serrated lock washers (13), and two washers (12) from front panel (4).
8.
Remove two screws (10) and lamp base (11) from front panel (4).
1.
Install lamp base (11) with two screws (10) on front panel (4).
2.
Install two serrated lock washers (13) and two washers (12) on two screws (10) and thread on two
nuts (14).
3.
Connect cables to terminals of lamp base (11).
4.
Insert bulb (9) and bayonet socket (8) into lamp base (11) until bulb is seated fully in socket.
5.
Connect cable to terminal (7) of bayonet socket (8) by tightening set screw.
6.
Install cover panel (6) on lamp base (11) of panel illumination H6.
7.
Stow prop (5) and close front panel (4).
8. Close flap (2).
4-117
