TM 9-6115-668-13
9.
Disconnect capacitor C2 (35) from VOLTAGE SELECTOR SWITCH S11 (34), and retain for re-use.
Connect capacitor C2 (36) to VOLTAGE SELECTOR SWITCH S11 (34)
with adhesive.
1.
Push VOLTAGE SELECTOR SWITCH S11 (34) with capacitor C2 (35) from the rear of front panel
(4).
2.
install plate (33) using screws (32) on front panel (4).
3.
Push dial plate (31) into frame of plate (32) until lugs snap into place.
4.
install switch knob (30) onto switch shaft and tighten screw (29).
5.
Connect cable (36) to terminals of VOLTAGE SELECTOR SWITCH S11 (34), noting correct label-
ing and position.
6.
Stow prop (5) and close front panel (4).
7. Close flap (2).
4 - 1 2 4
