TM 9-6115-662-13&PREPAIRWhen the rope (9) requires replacement, perform the following:a. Cut old rope (9) from box wrench (4).b. On new rope, flare each end to prevent unraveling.c. Install new terminal lug (7) to one end of rope (9).d. Thread other end of rope (9) through the opening in handle of load terminal wrench (4).e. Install conductor splice (5) to secure rope (9) to the wrench (4).INSTALLATION1.2.3.4.Place the loop clamp (6) so that mounting holes are in alignment with switch box cover holes.Drop terminal lug end of rope (9) with box wrench (4) through loop clamp (6) as shown in figure 4-10.Install screw (8), two flat washers (3), one terminal lug (7), new lock washer (2), and nut (1) thatsecures loop clamp (6) to switch box cover.Refer to paragraph 4-12 and perform steps 13 through 16 of Inspection.4-14 CLAMPING CATCH MAINTENANCE.This task covers: a. Removalb. InstallationINITIAL SETUPToolsTool Kit, General Mechanic’s(item 1, appendix B)Drill, 1/4-inch(item 2, appendix B)Riveter, Blind Head(item 5, appendix B)Material/PartsRivets, Blind HeadEquipmentConditionsReferenceBoth generator sets shut down,paragraph 2-5.3.1.Trailer support devices arelowered, paragraph 2-3.2.1.4-23
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
