TM  9-6115-660-13&P NOTES: 1. REMOVE BRAID FROM FOUR GROUND WIRES (12 AWG). TWIST TOGETHER AND INSTALL TERMINAL LUG, FIND NO. 4, AS SHOWN. TERMINAL SHALL BE INSTALLED IN ACCORDANCE WITH MIL-STD-454, REQUIREMENT 19. 2. AT PIGTAIL END OF CABLE, THE FOUR 12 AWG GROUNDING CONDUCTORS SHALL BE TWISTED TOGETHER, STARTING AT THE JACKET. CONDUCTORS SHALL BE SOLDER COATED FOR A LENGTH OF .25 FROM END USING SOLDER, FIND NO. 8. 3. AT PIGTAIL END OF CABLE, EACH INSULATED CONDUCTOR SHALL BE STRIPPED 1.25 FROM END AND HAVE THEIR INDIVIDUAL STRANDS TWISTED TOGETHER. SOLDER COAT FOR A LENGTH OF .12 FROM END USING SOLDER, FIND NO. 8. 4. INSULATION COLORS, IN ACCORDANCE WITH WIRE LIST, SHALL BE INCLUDED AS PART OF THE ORDERING DATA. 5. HOT STAMP “97403-13229F5836-” WITH APPROPRIATE DASH NO., AND ‘W-” IN .23-.39 HIGH CHARACTERS ON INSULATION SLEEVING, FIND NO. 5, IN ACCORDANCE WITH MIL-M-60903. 6. HOT STAMP WITH TERMINAL DESIGNATION. AS SHOWN ON WIRE LIST. USING .12-.22 HIGH CHARACTERS, IN TWO PLACES APPROXIMATELY 180° APART ON INSULATION SLEEVING, FIND NO. 6 AND 7, IN ACCORDANCE WITH MIL-M-60903. WIRE LIST - AN/MJQ-37  AND AN/MJQ-38 -60  AND 400 Hz TERMINATION TERMINATION DIMENSION DASH FIND FIND FIND CABLE  REF NO. WIRE FROM NO. TO NO. NO. A B c DES BLACK G1-L1 - K1-A2 2 1 23.50 44.00 4.00 RED G1-L2 - K1-B2 2 1 25.50 44.00 4.00 BLUE G1-L3 - K1-C2 2 1 27.50 44.00 4.00 -5 WHITE G1-L0 - L0 3 1 21.50 44.00 22.50 W1 GREEN G1-GND - GND 4 1 24.50 44.00 19.50 GREEN G1-GND - GND 4 1 24.50 44.00 19.50 GREEN G1-GND - GND 4 1 24.50 44.00 19.50 GREEN G1-GND - GND 4 1 24.50 44.00 19.50 BLACK G2-L1 - K2-A2 2 1 14.00 37.00 4.00 RED G2-L2 - K2-B2 2 1 12.00 37.00 4.00 BLUE G2-L3 - K2-C2 2 1 11.00 37.00 4.00 -6 WHITE G2-L0 - L0 3 1 11.00 37.00 17.00 W2 GREEN G2-GND - GND 4 1 9.00 37.00 14.00 GREEN G2-GND - GND 4 1 9.00 37.00 14.00 GREEN G2-GND - GND 4 1 9.00 37.00 14.00 GREEN G2-GND - GND 4 1 9.00 37.00 14.00 G-12 Figure G-5. Cable Assembly W1  and W2 (Sheet 2).