TM 9-6115-660-13&P
NOTES:
1.
2.
3.
4.
5.
CRIMP CONNECTIONS SHALL BE IN ACCORDANCE WITH MIL-E-45782.
INSTALL INSULATION SLEEVING, FIND NO. 6, OVER TERMINALS, FIND NO. 4 AND 5, AND HEAT SHRINK TO
A FIRM FIT.
HOT STAMP EACH WIRE, WITHIN 2.50 +/- .12 OF TERMINAL, WITH MARKINGS SPECIFIED IN TABULATION.
MARKINGS SHALL BE IN ACCORDANCE WITH MIL-M-60903, ON SLEEVING, FIND NO. 8.
HOT STAMP "W10" AND "97403-13229E5832-" WITH APPROPRIATE DASH NO. IN ACCORDANCE WITH MIL-M-
60903, ON SLEEVING, FIND NO. 8. APPLY SINGLE MARKING APPROXIMATELY CENTERED ON ANY ONE
WIRE.
MARK REFERENCE DESIGNATION IN .12 MIN. HIGH CHARACTERS IN ACCORDANCE WITH MIL-STD-130,
METHOD OPTIONAL.
Figure G-4. Output Connector Harness Assembly W10 (Sheet 1 of 2).
G-9
