4-18 LOAD TERMINAL COVER MAINTENANCE.

Figure 4-17. Switch Box Load Terminal Maintenance (sheet 2).

TM-9-6115-660-13P Power Plant Diesel Engine Driven 1-Ton Trailer Mounted (With Racks) 3Kw 60 Hz AN/MJQ-42 Manual
Page Navigation
102

INSTALLATION 1. 2. 3. 4. 5. Position new load provided. TM 9-6115-660-13&P terminal (8, figure 4-17 sheet 1) on mounting plate so that alignment pin fits in hole Install and tighten the hex nut (6). Install the leads (5). Install internal tooth lock washer (4) and thread hex nut (3) on load terminal (8) and tighten. Close switch box terminal cover (1) and switch box cover (2), and secure with clamping catches (11 and 12). 4-18 LOAD TERMINAL COVER MAINTENANCE. This task covers: a. Removal b. Installation INITIAL SETUP Tools Equipment Conditions Tool Kit, General Mechanic’s (item 1, appendix B) Reference Both generator sets shut down, para 2-5.3.3. Materials/Parts None REMOVAL 1. Release clamping catches (1, figure 4-18) and open switch box cover (2). 2. Release clamping catches (3) and open load terminal cover (4). 3. Remove six nuts (5), lock washers (6), screws (7), and flat washers (8) and remove load terminal cover (4) and stop (9) from switch box (10). NOTE If replacing load terminal cover, step 4 must be performed. 4. Remove four rivets (11) and two clamping catch strikes (12). Retain strikes for installation on new cover. INSTALLATION 1. Install load terminal cover (4) and stop (9), on switch box (10) with six screws (7), flat washers (8), lock washers (6), and nuts (5). 4-37

Privacy Statement
Press Release
Contact