TM 9-6115-659-13&P
g.
If rear lifting bracket is a replacement, install lifting rings (paragraph 4-21) and reflectors (paragraph 4-22).
h.
Position power cable clamp (21) and install screw (18), flat washer (19), and nut (20).
5-22 PU-797A AND AN/MJQ-35A GENERATOR MOUNTING RAIL MAINTENANCE.
This task covers:
a. Removal
c. Installation
b. Repair
INITIAL SETUP
Tools
Tool Kit, General Mechanic’s
(item 1, appendix B)
Rivet Gun (item 8, appendix B)
Materials/Parts
Rivets (items 6, 8, 9, and 10, appendix I)
Equipment Conditions
Reference
Trailer handbrakes set, front support
leg/landing leg lowered, and rear
leveling-support jack lowered; paragraph
2-3.2.1. Accessory box removed;
paragraph 4-19. Generator set removed;
paragraph 5-6. Center floor removed;
paragraph 5-16.1.
REMOVAL
Remove rivets (1 and 2, figure 5-25) and mounting rail (3) from trailer chassis (4).
REPAIR
Repair of generator mounting rails consists of replacing rivets (5) and doubler plates (6 and 7), and rivets (8) and angle
supports (9 and 10) as required.
INSTALLATION
Place mounting rail (3) on trailer chassis (4) and secure with rivets (1 and 2).
Change 2 5-51
