TM 9-6115-659-13&Pc.d.e.f.g.WARNINGChock wheels to prevent trailer from rolling. Failure to observe this warningcould result in severe personal injury or death.Release handbrakes (1).Separate brake relocating brackets (4) from frame by removing two self-locking nuts (6), flatwashers (5), and cap screws (3).Remove ten self-locking nuts (16), flat washers (15), and cap screws (17) from front liftingbracket (2).Remove three self-locking nuts (13), flat washers (14), and cap screws (12) that attach front liftingbracket (2) to top of frame.Remove front lifting bracket (2).2. REMOVE REAR LIFTING BRACKET.a.b.c.d.d.e.NOTEIf replacing rear lifting bracket, proceed to step a. If removing rear liftingbracket, proceed to step b.Remove lifting rings (paragraph 4-21) and reflectors (paragraph 4-22).Separate the tail light bracket (11) from trailer chassis by removing two self-locking nuts (8), flatwashers (9), and screws (10).Separate the power cable from rear lifting bracket (22) by removing nut (20, figure 5-24), flat washer(19), and screw (18) from cable clamp (21).Remove ten self-locking nuts (16), flat washers (15), and cap screws (17) from rear liftingbracket (22).NOTETwo sets of attaching hardware used on roadside and curbside top of bracketare removed when splash guard is removed.Remove screw (12), flat washer (14), and self-locking nut (13) from inboard top hole of rear liftingbracket (22).Remove rear lifting bracket (22).INSTALLATION1. INSTALL FRONT LIFIING BRACKET.a. Position front lifting bracket (2) on trailer chassis (7).5-49
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
