TM 9-6115-659-13&P
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
Loosely install ten cap screws (17), flat washers (15), and self-locking nuts (16) in front lifting
bracket (2).
Loosely install three cap screws (12), flat washers (14), and self-locking nuts (13) to attach front
lifting bracket (2) to top of curbside front corner of trailer chassis (7).
Install mounting rails (paragraph 5-18).
NOTE
Loosely installed screws (12 and 17) will aid in alignment of holes
in handbrake bracket.
Position brake relocating brackets (4), with attached handbrake lever (1), and loosely install four cap
screws (3), flat washers (5), and self-locking nuts (6).
Tighten all self-locking nuts installed in steps b. through e.
Install front generator set (paragraph 5-6).
If front lifting bracket is a replacement, install lifting rings (paragraph 4-21).
Position power cable clamp (21) and install screw (18), flat washer (19), and nut (20).
Set trailer handbrakes and remove wheel chocks.
Remove jack stands.
2. INSTALL REAR LIFTING BRACKET.
a. Position rear lifting bracket (22) on trailer chassis (7).
b. Loosely install ten cap screws (17), flat washers (15), and self-locking nuts (16) in rar lifting
bracket (22).
NOTE
Two sets of attaching hardware used on roadside and curbside top of bracket
are installed when splash guard is installed.
c. Loosely install cap screw (10), flat washer (14), and self-locking nut (13) to attach rear lifting
bracket (22) to top of trailer chassis (7).
NOTE
Loosely installed screws (12 and 17) will aid in alignment of holes in
handbrake bracket.
d. Install tail light bracket (11), two screws (10), flat washers (9), and self-locking nuts (8).
e. Tighten all self-locking nuts installed in steps b. and c.
f. Install rear generator set (paragraph 5-6).
5-50