TM 9-6115-659-13&P5-19 AN/MJQ-35 GENERATOR MOUNTING RAIL MAINTENANCEThis task covers:a. Removalc. Installationb. RepairINITIAL SETUPToolsEquipmentConditionsTool Kit, General Mechanic’s(item 1, appendix B)ReferenceTool, Blind Nut (item 2, appendix B)Trailer handbrakes set, front supportleg/landing leg lowered, and rearMaterials/Partsleveling-support jack lowered; paragraph2-3.2.1.Nuts, Self-lockingBoth generator sets removed paragraph 5-6.Nuts, BlindAccessory box removed; paragraph 4-19.Fenders and platform removed; paragraph4-25.REMOVALNOTERails may be shimed; note location and quantity. Mounting hardwarequantity may vary depending on mounting rail being removed. Longer boltsare used at front end of mounting rails.Remove self-locking nuts (1, figure 5-22), flat washers (2), cap screws (3) and mounting rail (4).REPAIRNOTEBlind nuts are located at front end of both mounting rails.Repair of mounting rails consists of replacing blind nuts (5). Refer to instructions supplied with blind nuttool.INSTALLATIONPosition mounting railnuts (1), then tighten.(4) on trailer and loosely install cap screws (3), flat washers (2), self-locking5-43
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
