TM 9-6115-659-13&P
REMOVAL
NOTE
Rails may be shimmed; note location and quantity. Mounting hardware quantity may vary
depending on mounting rail being removed.
Remove self-locking nuts (3, figure 5-21), flat washers (2), cap screws (1), and mounting rail (4).
REPAIR
NOTE
Blind nuts are located at rear of mounting rails for rear generator.
Repair of mounting rails consists of replacing blind nuts (5). Refer to instructions supplied with blind nut tool.
INSTALLATION
Install mounting rail (4), cap screws (1), flat washers (2), and self-locking nuts (3) on trailer chassis (6).
Figure 5-21. Replace AN/MIQ-35 Generator Mounting Rail.
Change 2 5-42
