5-16.1 PU-797A AND AN/MJQ-35A FLOOR AND FENDER MAINTENANCE.

Figure 5-20.1. PU-797A and AN/MJQ-35A Floor Replacement.

TM-9-6115-659-13P Power Unit PU-732/M (NSN 6115-00-280-3082) MEP-118A 15 Kw 400 Hz Generator Set M200A1 2-Wheel 4-Tire Modified Trailer Manual
Page Navigation
173

TM 9-6115-659-13&P 2. Unsolder diode (15) from stud terminal (14) and remove diode. INSTALLATION 1. Refer to wiring diagram (figure FO-1) and solder diode leads to terminal studs (14) as applicable. 2. Invert relay board assembly (4) and install four flat washers (3), lock washers (2), and screws (1). 5-16.1 PU-797A AND AN/MJQ-35A FLOOR AND FENDER MAINTENANCE. This task covers: a. Removal c. Installation b. Repair INITIAL SETUP Tools Tool Kit, General Mechanic’s (item 1, appendix B) Rivet Gun (item 8, appendix B) Materials/Parts Rivets, (items 6 and 7, appendix I) Equipment Conditions Reference Generator set shut down; paragraph 2-5.3.3. Trailer handbrakes set, front support leg/landing lowered, and rear leveling-support jacks lowered; paragraph 2-3.2.1. Generator sets removed as required (AN/MJQ-35A); paragraph 5-6 Switch Box assembly removed (AN/MJQ-35A roadside fender only); paragraph 4-13. REMOVAL 1. Floors. NOTE PU-797A and AN/MJQ-35A trailers have center and side floors or platforms riveted to the trailer. The side floors are in two sections. Remove rivets (1, figure 5-20.1) and floor sections (2) from trailer chassis (3). 2. Fenders. a. If necessary, remove the following. (1) Data plate (paragraph 4-22). (2) Fire extinguisher and bracket (paragraph 4-20). Change 2 5-40

Privacy Statement
Press Release
Contact