TM 9-6115-659-13&P2.For AN/MJQ-35, AN/MJQ-35A and AN/MJQ-36, carefully pull generator output plate (2) away from generator sethousing (3). For Power Plants and Power Units, pull until power cable leads and ground cable (6) are free ofgenerator set housing (3). Remove and retain gasket (7).NOTESteps 3 through 6 must be performed if removing AN/MJQ-35 front generator set.3.Remove four nuts (3, figure 5-6), flat washers (2), and screws (1) from cable clamps (4).4.Remove three nuts (7), six flat washers (6), and three screws (5) from inboard edge of splash guard (11).WARNINGUse the aid of an assistant when removing fender, splash guard, and switch box as anassembly. Failure to observe this WARNING can cause severe personal injury or death.5.Remove four nuts (10), eight flat washers (9), and four screws (8) from fender (12).6.Remove fender, splash guard, and switch box from trailer as an assembly.NOTEHardware holding generator sets on trailers differs between configurations. Whenremoving generator sets, refer to figure 5-7 to determine hardware used.7.Remove self-locking nuts (1, figure 5-7), flat washers (2), lock washers (4), and cap screws (3).8.Attach a four-leg sling to the four lifting/tiedown rings at the corners of the generator set skid base. The sling mustmeet the dimension requirements shown on the generator set lifting and tiedown diagram plate.WARNINGWhen lifting generator set, use lifting equipment with minimum lifting capacity of 1750pounds (793.8 kg). Do not stand or put arms, legs, or any part of body under hoistedload. Do not permit generator set to swing. Failure to observe this WARNING can resultin severe personal injury or death to personnel or damage to equipment.9.Using a wrecker, crane, or other lifting device having a lifting capacity of at least 1750 lb (793.8 kg) and sufficient liftingheight, lift generator set (6) from trailer.Change 2 5-10
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
