TM 9-6115-658-13&P F-7 NOTES:       1.    INSTALLED CRIMRED CONNECTIONS SHALL WITHSTAND AN AXIAL LOAD OF 8 POUNDS, SHALL HAVE CONTINUITY, AND SHALL SHOW NO EVIDENCE OF DAMAGE OR ARCING WHEN CRIMPED WITH TERMINAL MANUFACTURER’S RECOMMENDED CRIMPING TOOL.       2.    AT GENERATOR END OF CABLE, THE CONDUCTORS SHALL BE STRIPPED 1.00 FROM END, AND SHALL HAVE THEIR INDIVIDUAL STRANDS TWISTED TOGETHER STARTING AT THE JACKET.  CONDUCTORS SHALL BE SOLDER COATED FOR A LENGTH OF .25 + .12 FROM END, IN ACCORDANCE WITH MANUFACTURER COMMERCIAL PRACTICES.       3.    INSULATION COLORS, IN ACCORDANCE WITH WIRE TABLE, SHALL BE INCLUDED AS PART OF THE ORDERING DATA.       4.    HOT STAMP “97403-13230E6954” WITH APPROPRIATE DASH NO. AND “W[  ]”  NUMBER IN .12 MIN HIGH BLACK CHARACTERS ON INSULATION SLEEVING, FIND NO. 2.  HOT- STAMPED MARKING SHALL PROVIDE VISUAL CONTRAST AND SHALL BE IMPRESSED TO A DEPTH NOT EXCEEDING ONE-FOURTH THE THICKNESS OF MATERIAL FOR PERMANENCY AND LEGIBILITY.       5.    HOT STAMP TERMINAL DESIGNATION AS SHOWN IN WIRE TABLE, USING .09-.16 HIGH CHARACTERS, ON INSULATION SLEEVING, FIND NO. 3 HOT-STAMPED MARKING SHALL PROVIDE VISUAL CONTRAST AND SHALL BE IMPRESSED TO A DEPTH NOT EXCEEDING ONE-FOURTH THE THICKNESS OF MATERIAL FOR PERMANENCY AND LEGIBILITY. WIRE LIST TERMINATION TERMINATION DASH NO. WIRE NO. FROM FIND NO. TO FIND NO. WIRE COLOR AWG (REF) -1 1 G1-L1 - K1-A2 4 BLK 10 -1 2 G2-L2 - K1-B1 4 RED 10 -1 3 G1-N - N 5 WHT 10 -1 4 G1-GND - GND 5 GRN 10 -2 1 G2-L1 - K2-A2 4 BLK 10 -2 2 G2-L2 - K2-B2 4 RED 10 -2 3 G2-N - N 5 WHT 10 -2 4 G2-GND - GND 5 GRN 10