TM 9-6115-658-13&P F-9 PARTS LIST FIND NO. PART NO.   QUANTITY REQUIRED DESCRIPTION 1 M22759/16-16-9 AR WIRE, ELECTRICAL, 600 VOLT (16 AWG) 2 M525036-106 71 TERMINAL LUG, SMALL, RING, TONGUE, FULLY INSULATED (16-14 AWG .138 STUD SIZE) 3 M525036-110 9 TERMINAL LUG, SMALL, RING, TONGUE, FULLY INSULATED (16-14 AWG .375 STUD SIZE) 4 M525036-155 5 TERMINAL LUG  (16-14 AWG .500 STUD SIZE) 5 M53367-4-9 AR STRAP, TIE DOWN 6 M23053/5-107-9 1 INSULATION SLEEVING (1.50 L) 7 RB873 1 TERMINAL LUG, SMALL, RING, TONGUE, FULLY INSULATED (16-14 AWG .190 STUD SIZE) 8 M23053/5-105-9 104 INSULATION SLEEVING, ELECTRICAL (L AS REQD) 9 8949 1 TUBING, PLASTIC, SPIRAL WRAP (10.00 L) NOTES:       1.  BUNDLE WIRE HARNESS AT EACH BREAKOUT AND AT 3.00 MAX INTERVALS USING TIEDOWN STRAP, FIND NO. 5.       2.  HOT STAMP “97403-13230E6951 ON INSULATION SLEEVING, FIND NO. 6.  HOT- STAMPED MARKING SHALL PROVIDE VISUAL CONTRAST AND SHALL BE IMPRESSED TO A DEPTH NOT EXCEEDING ONE-FOURTH THE THICKNESS OF MATERIAL FOR PERMANENCY AND LEGIBILITY.       3.  EACH WIRE SHALL BE IDENTIFIED BY HOT STAMPING ADDRESS DESIGNATIONS USING .09-.16 HIGH BLACK CHARACTERS ON INSULATION SLEEVING, FIND NO. 8.   HOT-STAMPED MARKINGS SHALL PROVIDE VISUAL CONTRAST AND SHALL BE IMPRESSED TO A DEPTH NOT EXCEEDING ONE-FOURTH THE THICKNESS OF MATERIAL FOR PERMANENCY AND LEGIBILITY.  ATTACH WITHIN TWO INCHES OF BOTH END TERMINATIONS.  ADDRESS SHALL CONSIST OF THE “FROM TERMINATION”, A DOUBLE HEADED ARROW, AND THE “TO TERMINATION”.   EXAMPLE:  XK3-2 AA TB1-1.       4.  WIRES SHALL BE STRIPPED 1.00 FROM END, AND SHALL HAVE THEIR INDIVIDUAL STRANDS TWISTED TOGETHER STARTING AT THE JACKET.  CONDUCTORS SHALL BE SOLDER COATED FOR A LENGTH OF .25 + .12 FROM END, IN ACCORDANCE WITH MANUFACTURER’S COMMERCIAL PRACTICES. 6.  INSTALLED CRIMPED CONNECTIONS SHALL WITHSTAND AN AXIAL LOAD OF 8 POUNDS, SHALL HAVE CONTINUITY, AND SHALL SHOW NO EVIDENCE OF DAMAGE OR ARCING WHEN CRIMPED WITH TERMINAL MANUFACTURER’S RECOMMENDED CRIMPING TOOL.