TM 9-6115-604-34
NAVFAC P-8-633-34
Figure 2-9. Generator G1, Lifting
(11)
Remove mounting bolts securing engine to rebuild stand (3375955 or equivalent).
WARNING
To minimize potential falling damage, clear the area of personnel and other equipment when
attempting to lift heavy equipment.
(12)
Hoist engine from rebuild stand and install through the front of the generator set and position engine over
front and rear engine mounting holes.
(13)
Install front engine support to skid base with hexagon capscrews (2, Figure 2-5), bevel washers (3),
lockwashers (4), and hexagonal nuts (5). Hand tighten only at this time.
(14)
Lower engine to mate front engine support (1) with engine trunnion and install hexagon capscrews (10),
bevel washers (11), lockwashers (1 2), and hexagonal nuts (13). Hand tighten only at this time.
(15)
Install rear engine supports (6) to engine using hexagonal head capscrews (14) and lockwashers (15).
Tighten, but do not torque.
(16)
Lower engine as necessary to align rear engine mounting supports to skid base and install hexagon
capscrews (7), washers (8), and hexagonal nuts (9). Leave hand tight.
2-33