Figure 9-59. Removal and Installation of Vibration Damper and Crankshaft Pulley

9-33. FRONT AND REAR CRANKSHAFT AND ACCESSORY DRIVE SEALS REPLACEMENT.

TM-9-6115-604-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 Kw. 1 Phase-2 Wire 1 Phase -3 Wire 3 Phase -4 Wire 120. 120/240 and 120/208 Volts Manual
Page Navigation
402

TM 9-6115-604-34 NAVFAC P-8-633-34 Figure 9-59. Removal and Installation of Vibration Damper and Crankshaft Pulley c. Install. (1) If removed, install the roll-pin (5, Figure 9-59) in the end of the crankshaft. (2) Fabricate two guide studs from spare capscrews (1), part number 3023539 (refer to Table 2-2) and install them in the crankshaft 180 degrees apart. CAUTION To avoid engine vibration caused by runout, be sure all paint or other foreign material Is removed from the mating surfaces of the crankshaft, vibration damper, and crankshaft pulley prior to Installation. NOTE Two persons will be required to perform the following procedure. (3) Align the roll-in hole in the vibration damper (4, Figure 9-59) with the roll-pin (5) in the crankshaft, and slide the vibration damper over the guide studs. (4) Align the crankshaft pulley (3) and install it over the guide studs. 9-106

Privacy Statement
Press Release
Contact