Figure 9-58. Cylinder Block Height Measurement
Lubricate new packings (39) with lubricating oil, MIL-L-45199, and install in the grooves of the 12 piston
cooling nozzles (38). Align the screw head recess in the nozzle with the threaded hole, install the nozzles,
and secure them with capscrews (37). Tighten the capscrews to 60 to 96 pound-inches (7 to 11 newton-
Install the thrust bearing retainer (36), and secure it with capscrews (35). Tighten the capscrews to 30 to
35 pound-feet (41 to 47 newton-meters).
Install the crankshaft in accordance with paragraph 9-27.
Install the connecting rod and piston assemblies in accordance with paragraph 9-20.
Install the rear gear housing and flywheel housing in accordance with paragraph 9-35.
Install the flywheel in accordance with paragraph 9-34.
Install the camshaft bushings in accordance with paragraph 9-16.
Install the timing gears and housing in accordance with paragraph 9-18.
Install the camshafts in accordance with paragraph 9-15.
Install the lubrication system components in accordance with Chapter 8 and the Operator and
Organizational Maintenance Manual.
Install the cooling system components in accordance with Chapter 7 and the Operator and Organizational