TM 9-6115-604-34
NAVFAC P-8-663-34
Table 1-4. Repair and Replacement Standards (Continued)
DIMENSIONAL DATA INCH (mm)
DESCRIPTION
FIG. NO.
REF.
MIN
MAX
WEAR LIMIT
NO.
FUEL SYSTEM (CONT)
FUEL INJECTION PUMP
(CONT)
Throttle shaft (upper
Figure 6-11
31
0.560
0.563
governor), bushings inside
(14.22)
(14.30)
diameter
Gear Pump
Cover and housing bushing
Figure 6-8
9
0.5013
0.5016
inside diameter
(12.733)
(12.741)
Gear protrusion from
Figure 6-8
7,10,
-0.0001
+0.0005
housing
13
(-0.003)
+(0.013)
Gear tooth flank clearance
Figure 6-8
10 13
0.006
0.010
(0.15)
(0.25)
Gearwidth
Figure 6-8
10,13
1.2483
1.2486
(31.707)
(31.714)
Housing, gear bore depth
Figure 6-8
7
1.2482
1.2485
(31.704)
(31.712)
Shafts, outside diameter
Figure 6-8
11,12
0.4998
0.5001
(12.695)
(12.703)
Shafts, protrusion from
Figure 6-8
7,11,
2.370
2.412
housing 12
12
(60.2)
(61.3)
Mainshaft, Cover, and
Governor
Gear backlash
Figure 6-12
9, 28,
0.005
0.009
34, 44
(0.13)
(0.23)
Idler gear to bushing end
Figure 6-12
34, 35
0.002
0.007
clearance
(0.05)
(0.18)
Idler shaft bushing inside
Figure 6-12
35
0.507
diameter
(12.88)
Shaft bushing, inside
Figure 6-12
10, 45
0.504
diameter
(12.80)
Sleeve bearing, inside
Figure 6-12
16
0.3963
0.3970
diameter
(10.066)
(10.084)
Tachometer drive shaft,
Figure 6-12
13
0.3950
0.3955
outside diameter
(10.033)
(10.046)
Tachometer driven gear
Figure 6-12
17
0.3948
inside diameter
(10.028)
Tachometer driven gear to
Figure 6-12
16,17
0.002
0.005
sleeve bearing end
(0.05)
(0.13)
clearance
1-19
