TM 9-6115-604-34 NAVFAC P-8-633-34 (25) Install the timing pointer (10), and secure with capscrew (8) and lockwasher (9). (26) Fabricate  two  guide  studs  (refer  to  Table  2-2)  and  install  them  in  the  upper  holes  on  each  side  of  the housing.  If removed, install the dowels (7, Figure 9-15). POSITION OF THE CAMSHAFT KEY AS SEEN FROM THE GEAR COVER END OF THE CAMSHAFT. INJECTION TIMING TIMING PISTON TRAVEL INCHES (mm) PUSH ROD TRAVEL INCHES (mm) A.J -0.2032(5.161) 0.126 ±0.002 (3.20 ±0.05) PART NUMBER AMOUNT OF CHANGE IN ANGLE OF OFFSET DE- OFFSET INCH PUSH ROD GREES MINUTES (mm) TRAVEL INCH (mm) 200711 0.0070 0.0033 0 20 (0.178) (0.084) 200709 0.0150 0.0070 0 42 (0.381) (0.178) 200704 0.0197 0.0095 0   56 (0.500) (0.241) 200708 0.0230 0.0110 1   5 (0.584) (0.279) 200706 0.0238 0.0155 1   33 (0.833) (0.394) 200714 0.0390 0.0185 1 50 (0.991) (0.470) 206782 0.0110 0.0055 0   31 (0.279) (0.127) 216294 0.0035 0.0017 0    10 (0.089) (0.043) Figure 9-23.  Timing of Camshafts 9-43