Assembly - TM-9-6115-464-34

Cleaning, Inspection, and Repair - TM-9-6115-464-34_435

Figure 5-13. Wheel Mounting Kit, Exploded View (Sheet 1 of 2)

TM-9-6115-464-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 15 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
414

ARMY TM 9-6115-464-34 AIR FORCE TO 35C2-3-445-2 NAVY NAVFAC P-8-624-34 d.Assembly. (1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11) (12) (13) (14) (15) (16) (17) Position ID plate (102, figure 5-13) and secure with rivets (101). Install beveled washer (100), capscrew (99), flatwasher (98), Iockwasher (97) and nut (96). Install grease seal (95), inner bearing (94), bearing race (93), hub (92), bearing race (91), outer bearing (90), studs (89), and (88), wheel half (87), into tire (86), wheel half (85), key washer (84), castellated nut (83), cotter pin (82), grease cap (81), screw (80), Iockwashers (79 and 78), nuts (77 and 76). Install brake drum (75), brake shoe (74), return spring (73), hold-down spring (72) and camshaft (71). Install sprindle and knuckle (70), safety chain (69), front axle (68), tow bar (67), hinge pin (66), latch (64), spring (63), roll pin (62) and cotter pin (65). Install center arm (61), tow bar (60), spacer washer (59), pin (58), cotter pin (57). Install grease fitting (56), and tie rod end (55). Install spindle and knuckle (54), king pin (53), roll pin (52), grease fitting (51). Install grease fitting (50), nuts (44 and 45), tube (43), tie rod end (49), bolt (48), nut (47), and cotter pin (46). Install bolt (42), nut (41), and cotter pin (40). Install rear axle (39), backing plate (38), bolt (37), Iockwasher (36), and nut (35). Install lever (34), bolt (33), Iockwasher (32) and nut (31). Install cross shaft (30), lever (29), pin (28), yoke (27), and pin (26). Install yoke (25), pin (24), rod (23), and nut (22). Install bearing block (21), grease fitting (20), lever (19), pin (18), bolt (17), Iockwasher (16), and nut (15). Install yoke (14), yoke (13), and cotter pin (12). Install yoke (11), hand lever assembly (10), pin (9), washer (8), cotter pin (7), spacer (6), nut (5), Iockwasher (4), bolt (3), rod (2) and nut (1). e. Installation. Refer to paragraph 5-15 for wheel mounting kit installation procedures. 5-33

Privacy Statement
Press Release
Contact